BRAND NEW EDELBROCK SMALL BLOCK CHEVY EPS PERFORMER INTAKE MANIFOLD KIT FOR 1957-1986 SMALL BLOCK CHEVY
DESIGNED FOR 1986 AND EARLIER 262-400 CUBIC-INCH CHEVYS, THE PERFORMER EPS DUAL-PLANE MANIFOLD IS OPTIMIZED TO DELIVER SUPERIOR PERFORMANCE WITH EDELBROCK SQUARE-BORE PERFORMER SERIES OR THUNDER SERIES AVS CARBURETORS. THIS SMALL-BLOCK CHEVY MANIFOLD HAS A RUNNER DESIGN THAT IS "TUNED" FOR PEAK TORQUE AROUND 3500 RPM ON A 350-INCH ENGINE AND IT IS IDEAL FOR POWER FROM OFF-IDLE TO 5500 RPM.
DYNO TESTS SHOWED GAINS OF 5 HP AND 9 FT/LBS OF TORQUE OVER THE EDELBROCK PERFORMER MANIFOLD 350-2101 ON A 350 CHEVY. FROM 3000 TO 4500 RPM, THE INCREASES AVERAGED 5+ FT/LBS. OF TORQUE FOR MORE PERFORMANCE WHERE YOU NEED IT MOST. LOOK FOR THE PERFORMER EPS TO "UP THE STANDARDS" IN DUAL-PLANE INTAKE MANIFOLD DESIGN. MATCH WITH A DEPENDABLE EDELBROCK SQUARE-BORE CARBURETOR FOR MAXIMUM PERFORMANCE GAINS.
NOTE: USE RTV SEALANT TO PROPERLY SEAL END SEALS, SUCH AS EDELBROCK HIGH TEMP SILICONE SEALANT #1076, DO NOT USE END SEALS GASKETS.; SEALANT MUST BE USED ON INTAKE BOLT THREADS IF THE THREADS EXTEND INTO LIFTER VALLEY OR COOLANT PASSAGE
NOTE: NPT/PIPE THREAD FITTINGS REQUIRE THE USE OF TEFLON TAPE OR PASTE ON THREADS TO ENSURE PROPER SEAL
NOTE: DO NOT OVERTIGHTEN NPT/PIPE FITTINGS, THIS MAY CAUSE THE ALUMINUM TO CRACK AROUND THE FITTING BOSS. NPT/PIPE THREAD IS A TAPERED THREAD
NOTE: HARDENED WASHERS MUST BE USED WITH INTAKE BOLTS TO ENSURE PROPER TORQUE AND PREVENT GALLING OF THE ALUMINUM
NOTE: WILL NOT FIT UNDER STOCK CORVETTE HOOD
NOTE: PROPER INSTALLATION IS THE RESPONSIBILITY OF THE INSTALLER. IMPROPER INSTALLATION WILL VOID YOUR WARRANTY AND MAY RESULT IN POOR PERFORMANCE AND ENGINE OR VEHICLE DAMAGE
KIT INCLUDES ALL THE NECESSARY COMPONENTS TO REPLACE YOUR EXISTING INTAKE:
